Printronix P7000 H-Series - Manual (Page 99)

99
Select Italic Font, 63
Select Print Quality, 63
Select Printer, 64
Select Superscript/Subscript Printing, 64
Select Vertical Printing, 65
Select 1/6-inch Line Spacing, 50
Select 1/8-inch Line Spacing, 50
Select 10 CPI, 51
Select 12 CPI, 51
Select 120-dpi Graphics, 52, 53
Select 15 CPI, 51
Select 240-dpi Graphics, 53
Select 60-dpi Graphics, 52
Sequences, escape, 29
Sequences, FS, 29
Set Absolute Horizontal Print Position, 67
Set and Reset Codes, 30
Set Bottom Margin, 67
Set DBCS Character Half Width, 68
Set Horizontal Tabs, 68
Set Intercharacter Space, 69
Set Intercharacter Spacing of DBCS Character
(Hangul Extension), 69
Set Intercharacter Spacing of SBCS Character
(Hangul Extension), 70
Set Left Margin, 70
Set n/180-inch Line Spacing, 66
Set n/60-inch Line Spacing, 66
Set Page Length in Inches, 71
Set Page Length in Lines, 71
Set Relative Horizontal Print Position, 72
Set Right Margin, 72
Set Vertical Tab Channels, 73
Set Vertical Tabs, 73
Set Vertical Tabs in VFU Channels, 74
Software features, 9
Super-Set Commands, 30
Supplies Department, 95
T
Tab Horizontally, 75
Tab Vertically, 75
Turn Auto-wrap Around On/Off, 76
Turn Double-height Printing On/Off, 76
Turn Double-width Printing On/Off, 77
Turn Double-width, Double-height Printing On/Off,
77
Turn Extending Table Character On/Off, 78
Turn On/Off OCRB selection, 78
Turn Proportional Mode On/Off, 79
Turn Underline On/Off, 79
Turn Underline On/Off (Hangul Extension), 80
Typeface, setting with control panel, 23
U
Unsupported features, 27
Z
20 CPI Condensed parameter, 26
80-9F hex, configuring, 26