Printronix P7000 H-Series - Manual (Page 58)

58
Chapter 3 Configuring The KSSM Emulation With Control Codes
Select Condensed Printing
ASCII Code ESC SI
Hex Code 1B 0F
Dec Code 27 15
Purpose Enters condensed mode, in which character width is reduced
as follows:
Comment This command is ignored under the following two conditions:
15-cpi printing has been selected with the ESC g command.
This command reduces character width by about 50% when
proportional spacing is selected with the ESC p command.
Cancel condensed printing with the DC2 command.
If the front panel setting of “20 CPI Condensed” is Disable,
12-cpi printing will ignore the Condense command.
The default is Non-condensed printing.
Cancel Condensed Printing
ASCII Code DC2
Hex Code 12
Dec Code 18
Purpose Cancels condensed printing selected by the SI or ESC SI
commands.
Comment The default is Normal (non-condensed) printing.
Selected pitch Condensed pitch
10 cpi 17.14 cpi
12 cpi 20 cpi
Proportional ½ width