Printronix P7000 H-Series - Manual (Page 69)

Set Intercharacter Space
69
A maximum of 32 horizontal tabs can be set.
The printer does not move the print position to any tabs beyond
the right-margin position. However, all tab settings are stored in
the printer’s memory; if you move the right margin, you can
access previously ignored tabs.
The printer calculates tab positions based on 10 cpi if
proportional spacing is selected with the ESC p command.
The default is every eight characters.
Set Intercharacter Space
ASCII Code ESC SP n
Hex Code 1B 20 n
Dec Code 27 32 n
Purpose Increases the space between characters; the unit is according
to the current density.
Where:
0 <=
n <= 127
Comment The extra space set with this command doubles during double-
width mode.
Set Intercharacter Spacing of DBCS Character
(Hangul Extension)
ASCII Code FS S n
1
n
2
Hex Code 28 53 n
1
n
2
Dec Code 1C 83 n
1
n
2
Purpose Sets intercharacter space to the left and right of the DBCS
character.
n
1
Specifies the space to the left of the printed character.
n
2
Specifies the space to the right of the printed character.
The dot size of n
1
and n
2
is 1/180 inch.
Where:
0 <
n
1
< 127
0 < n
2
< 127
Comment A DBCS character with a half-width feature set by the FS SI
command is treated as an SBCS character.
This command also affects an SBCS character if the character
is aligned with DBCS by the FS U command.
If the SBCS character is aligned with the DBCS character, the
intercharacter space of the SBCS character is half of
n
1
and n
2.
This command affects the front panel setting of “DBCS CPI.”
The default is n
1
= 0, n
2
= 3.