Printronix P7000 H-Series - Manual (Page 28)

28
Chapter 3 KSSM Emulation
Default Values And States
Your printer stores a set of typical operating states and conditions in the flash
memory. The first time you power up the printer, the factory settings in Table
4 are automatically invoked.
Table 4. Factory Settings
Characteristic Default Setting
Select LPI 6.0
Select CPI 10.0
DBCS CPI 6.0
Host Command Enable
Typeface LQ
Styling Type Myungjo
High Density Disable
Bold Print Disable
Italic Print Disable
Slashed Zero Disable
DBCS/ASCII Mode DBCS Mode
DBCS ASCII Style Normal
Text Position Bottom of Line
Encoding Address Table
Taller 15 CPI Disable
Graphics Spd Up Normal
Left Margin 0 columns
Right Margin 0 columns
Bottom Margin 0 lines
Perforation Skip Disable
Form Length 11.0 inches
279.4 millimeters
66 lines
Form Width 13.6 inches
345.4 millimeters
163 characters
Reset Cmd CFG Ld Disable
Illegal Code Pt. Normal
Define CR Code CR = CR