Printronix P7000 H-Series - Manual (Page 70)

70
Chapter 3 Configuring The KSSM Emulation With Control Codes
Set Intercharacter Spacing Of SBCS Character
(Hangul Extension)
ASCII Code FS T n
1
n
2
Hex Code 28 54 n
1
n
2
Dec Code 1C 84 n
1
n
2
Purpose Sets intercharacter space to the left and right of the SBCS
character.
n
1
Specifies the space to the left of the printed character in
1/180 of an inch.
n
2
Specifies the space to the right of the printed character in
1/180 of an inch.
The units of n
1
and n
2
are 1/180 inch.
Where:
0 <
n
1
< 127
0 < n
2
< 127
Comment A DBCS character with a half-width feature set by the FS SI
command is treated as an SBCS character.
This command only affects SBCS characters when the FS V
command is set.
The default is n
1
= 0, n
2
= 2.
Set Left Margin
ASCII Code ESC I n
Hex Code 1B 6C n
Dec Code 27 108 n
Purpose Sets the left margin to n columns in the current character pitch,
as measured from the left-most printable column.
Where:
1 <=
n <= 255
0 < left margin < right margin
Comment In DBCS mode, the character pitch is according to the width of
the DBCS character.
This command affects the front panel setting of “Left Margin.”
The default depends on the power-up configuration.