Polycom KIRK KWS6000 - Manual (Page 113)

12–1
12
Configuring KIRK Base Station
This section provides you with information on how to connect the base station
to a KWS6000 and how to configure the base station through the web based
Administration Page using either DHCP or static IP address.
This section includes information about:
•
“Powering up the KIRK Base Station” on page 12-1
• “Connecting a Computer to the KIRK Base Station” on page 12-2
• “Accessing the Web Based Administration Page” on page 12-3
• “Configuring a KIRK Base Station Using DHCP” on page 12-6
• “Configuring a KIRK Base Station Using Static IP Address” on page 12-9
• “Checking Indicators” on page 12-11
• “Making a Back-Up of the Configuration File” on page 12-11
Powering up the KIRK Base Station
After installing the base station you need to power it up. The base station uses:
• Power over Ethernet (PoE 802.3af).
• Maximum power supply consumption is 3.0W (IEEE 802.3af class 1
device).
Use a standard PoE adapter or a PoE-enabled port on a switch adhering to PoE
802.3af when connecting the base station to a PoE power source.
Note
The base station is pre-configured to use DHCP. It is strongly
recommended to configure the base station using DHCP.