Palm TREOTM 650 User Manual
Page 195
FCC :: 193
FCC
FCC Statement This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Safety Exposure To Radio Frequency Energy (SAR) Radio
transmitting devices radiate Radio Frequency (RF) energy during its
operation. RF energy can be absorbed into the human body and potentially
can cause adverse health effects if excessive levels are absorbed. The unit
of measurement for human exposure to RF energy is “Specific Absorption
Rate” (SAR).
The Federal Communications Commission (FCC), Industrie Canada (IC),
and other agencies around the world have established limits that
incorporate a substantial safety margin designed to assure the safety of all
persons using this equipment.
In order to certify this unit for sale in the US, Canada and Europe this
unit has been tested for RF exposure compliance at a qualified test
laboratory and found to comply with the regulations regarding exposure to
RF Energy.
SAR was measured with the unit transmitting at its maximum certified
RF power. Often, however, during normal operation the unit will transmit
much less than maximum power. Transmit power is controlled
automatically and, in general is reduced as you get closer to a cellular base
station. This reduction in transmit power will result in a lower RF energy
exposure and resulting SAR value.
FCC RF Safety Statement In order to comply with FCC RF exposure
safety guidelines, users MUST use one of the following types of bodyworn
accessories.
1. A palmOne™ brand body-worn accessory that has been tested for SAR
compliance and is intended for use with this product.
2. An accessory that contains NO metal (snaps, clips, etc) and provides AT
LEAST 1.5 cm of separation between the users body and the unit.
Do NOT use the device in a manner such that it is in direct contact with
the body (i.e. on the lap or in a breast pocket). Such use will likely exceed
FCC RF safety exposure limits See www.fcc.gov/oet/rfsafety/ for more
information on RF exposure safety.
Responsible party
(North America)
(Europe)
palmOne, Inc.
Bornibus Francois
400 N. McCarthy Blvd.
Buckhurst Court
Milpitas, CA 95035
London Road
USA
Wokingham, Berkshire RG40 1PA,
Antenna Care/Unauthorized Modifications Use only the supplied
integral antenna. Unauthorized antenna modifications or attachments
could damage the unit and may violate FCC regulations. Any changes or
modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Potentially Unsafe Areas Potentially explosive atmospheres: Turn off your
smartphone when you are in any areas with a potentially explosive
atmosphere, such as fueling areas (gas or petrol stations) or storage
facilities for fuel or chemicals.
Declaration of Conformity
Treo Model 650
palmOne declares that the above model of Treo smartphone is compliant
with the regulations below. The declaration applies to the smartphone and
its associated accessories (power supply, headset, and USB cable) where
applicable.
Maximum Scaled SAR Values (W/kg)
Band (MHz) 850 900 1800 1900
Head SAR: 1.51 1.39 .541 .943
Body SAR: 1.46 1.27 .421 .688
EMC: EN 301 489 EN 301 419-1 (Apr 2000)
EN 310 420 (Dec 1999) ANSI/IEEE C95.1 1992
EN 50360 (July 2001) EN 50361 (July 2001)
FCC OET Bulletin 65 Supplement C
Safety: EN 60950: 2000 (Jan-2000)
Radiated Emissions: EN 55022 Immunity: EN 55024
RowdyUG.book Page 193 Tuesday, December 7, 2004 9:58 AM