Fixing problems – Philips 765 User Manual
Page 23
21
If you think your CD Recorder/Player is defective, it is wise
to check this list first, and run the diagnostic program.
Maybe you have forgotten a simple step.
Warning!
U
Un
nd
de
err n
no
o c
ciirrc
cu
um
msstta
an
nc
ce
ess ssh
ho
ou
ulld
d yyo
ou
u a
atttte
em
mp
ptt tto
o rre
ep
pa
aiirr
tth
he
e C
CD
D R
Re
ec
co
orrd
de
err//P
Plla
ayye
err yyo
ou
urrsse
ellff a
ass tth
hiiss w
wiillll iin
nvva
alliid
da
atte
e
tth
he
e g
gu
ua
arra
an
ntte
ee
e..
S
SY
YM
MP
PT
TO
OM
M:• SOLUTION:
N
No
o p
po
ow
we
err • check to ensure that the ON/OFF button is on
• check to ensure that the power cable is
plugged in correctly
• switch the recorder OFF and then immediately
back ON
A
Au
utto
o ttrra
ac
ck
k d
do
oe
ess n
no
ott w
wo
orrk
k
• check to ensure that auto track is selected.
• check to ensure that there are 3 seconds
silence in between the tracks (analogue
recording only)
• check to ensure that the source is a consumer
source with the digital outputaccording the
IEC audio standard.
N
No
o sso
ou
un
nd
d
• check the audio connections
• if using an amplifier, try using a different
source
A
Am
mp
plliiffiie
err sso
ou
un
nd
d iiss d
diisstto
orrtte
ed
d
• check to ensure that the CD Recorder/Player
analogue output is not connected to the
amplifier Phono input.
P
Plla
ayy w
wiillll n
no
ott sstta
arrtt
• check to ensure that the label of the CD is
facing up
• clean the disc
• check to ensure that the disc is not defective
by trying another disc
• make sure that the disc has been finalized for
play in a CD player.
R
Re
em
mo
otte
e c
co
on
nttrro
oll d
do
oe
ess n
no
ott w
wo
orrk
k
• point the remote control directly at the
CD Recorder/Player
• check the batteries and replace if necessary
• select the right source first
W
Wiillll n
no
ott rre
ec
co
orrd
d
• clean the disc
• check to ensure that CD-RW is not finalized
• check to ensure that the disc is recordable
and replace if necessary
• make sure the disc is an AUDIO disc
(
noAUDIO may not appear)
• wrong input source selected.
A
An
na
allo
og
g rre
ec
co
orrd
diin
ng
g iiss d
diisstto
orrtte
ed
d
• make sure the recording level is correct
2200 sse
ec
co
on
nd
d p
pa
au
usse
e b
be
ettw
we
ee
en
n rreecco
orrd
diin
ng
gss
• see Synchronized digital recording (CD-SYNC)
p.15
P
Plla
ayye
err d
do
oe
ess n
no
ott rre
ea
ac
ctt
• switch the ON/OFF button on the front of the
player off and back on
RECOUER on display
• a power failure has occured during recording,
the CD Recorder/Player is attempting to repair
the disc.
• if
RC-DISC then appears on the display,
the disc cannot be recorded further, and
cannot be finalized. It can, however, still be
played on the CD Recorder/Player or on
another CD recorder.
• on a CD-RW disc, the track being recorded is
lost, but further recording and finalization can
still be done.
• If
NO-OPC appears on the display, the disc
cannot be used for recording. However, it can
still be used as a CD on this recorder.
NO-REC on display
• While scanning a CD before recording, a non-
audio track was detected. This track cannot be
copied and will be skipped.
If the malfunction persists, perform the Diagnostic Program:
1 Switch the CD Recorder/Player off using ON/OFF.
2 Simultaneously press PLAY and STOP and switch the CD
Recorder/Player back on using ON/OFF.
‹
The display will now indicate
BUSY and after a few
minutes, the message will change to
---- or
PASSED
• If the
---- message appears, your recorder is
defective and needs to be repaired. Consult your supplier
or call the Philips Consumer Line to find the nearest
service centre. The number of the Consumer Line can be
found in the guarantee booklet.
• If the
PASSED message appears, you may be
misinterpreting the user instructions or using an
inappropriate disc, or there may be a mechanical defect
or an incorrect connection. Carefully read the user
instructions once again; and if necessary contact your
supplier.
• If you cannot solve the problem, contact to the nearest
service centre.
3 Switch off the CD Recorder/Player using ON/OFF to exit
from the Diagnostic Program.
Diagnostic program
Troubleshooting
English
FIXING PROBLEMS