Philips 765 - Manual (Page 17)

15
Note: A AU UT TO O T TR RA AC CK K works only with Consumer Sources with
a digital output signal according to the IEC 958
(consumer part) audio standard.
Start digital recording
1 With the recorder stopped, press RECORD to enter the
Record standby mode.
‹
RECORD flashes.
• If DIG also flashes, the digital connection is incorrect.
2 To start recording, press PLAY on the CD Recorder/Player
and immediately start the source (from the stop mode).
‹
RECORD lights continuously. The track number and
recording time used will be indicated on the display.
•• To record a three-second pause (silence) at the beginning
of a track, press PAUSE on the CD Recorder/Player.
• To check the (remaining) recording time, press DISPLAY.
(This can also be done during the recording.)
33 To stop recording, press STOP on the CD Recorder/Player.
‹
RECORD will go out.
• To interrupt recording, press PAUSE.
‹
RECORD starts to flash. Resume at step 2.
After recording the display will show UPDATE for several
seconds.
Note: With AUTO TRACK on, the recorder will stop
automatically. Recordings from DAT or DCC will
stop after 20 seconds silence. With
AUTO TRACK off,
the AUTO STOP mode is disabled.
Preparing for synchronized digital recording
The CD-SYNC feature enables you to make fast and easy
digital recording of a CD. Track increments are automatically
detected from the digital source material. Track increments
cannot be added manually.
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press SOURCE repeatedly until (depending on the
connection used):
‹
DIG
DIGITAL or
DIG
OPTICAL will appear on
the display.
• If necessary, press DUAL to switch off the D DU UA ALL mode;
D DU UA ALL will no longer appear on the display.
Start synchronized digital recording
1 With the CD Recorder/Player stopped, press CD-SYNC.
‹ On the display, CD - SYNC &
SYNC appear. After a time,
RECORD starts to flash.
• If DIG also flashes, the digital connection is incorrect.
2 To start recording, press PLAY on the external digital
source.
‹
The CD Recorder/Player automatically starts to record
and
RECORD lights continuously. The track number and
recording time used will be indicated on the display
• If you start the source during a track, CD-SYNC will not
start recording until the beginning of the next track.
CD SYNC SRC
SHUFFLE SHUFFLE SCAN
RECORD
FINALIZE
ERASE DUAL
TIME
TRACK OVER
TOTAL REM TIME
REPEAT 1 REPEAT 1 DIG
DUBB 1
TOTAL
PAUSE PAUSE PROG PROG OPT ANALOG
REM TRACK AUTO TRACK TRACK
TRACK
CD SYNC SRC
SHUFFLE SHUFFLE SCAN
RECORD
FINALIZE
ERASE DUAL
TIME
TRACK OVER
TOTAL REM TIME
DUBB 1
TOTAL REM TRACK AUTO TRACK TRACK
TRACK
DISPLA Y
SOURCE
REC LEVEL
DUAL DISPLA Y
PHONES
OPEN
CLOSE
C O M P A
C T D I S
C R E C O
R D E R C
D R 7 6 5
CD-SYNC
DUBB
AUTO/ M
CD SYNC
SCAN
REWRITABLE
RECORD
CD
TIME
TRACK
OVER
TOTAL REM
TIME
REPEAT 1
REPEAT 1
DIG
DUBB 1
TOTAL
PAUSE
PAUSE
REM
TRACK
Synchronized digital recording from an
external CD player - CD-SYNC
CD SYNC SRC
SHUFFLE SHUFFLE SCAN
RECORD ERASE DUAL
TIME
TRACK OVER
TOTAL REM TIME
DUBB 1
TOTAL REM TRACK AUTO TRACK TRACK
TRACK
FINALIZE
English
RECORDING