Paxar Gold 6037EX - Manual (Page 206)

7-26 Programmer’s Manual
Message Solution
Supplied Buffer was too small
for amount of data. Call Technical Support at the phone
number on the back of this manual.
Ultra returned Negative
response. The printer timed out before it could
complete the command. Increase
the length of the timeout with the
settimeout command and retry the
command that timed out.
Unknown Command Verify the spelling of the command
name and re-enter it.
Unknown Drive Letter Retry the udiskfree command, but
specify either
c or d as the drive
letter.
Unknown Error (Error = xxx). A UServe error occurred. Physically
reboot the printer (not with the
reboot command), start UServe, and
try the command again. If the error
still occurs, have the printer
serviced.