Paxar Gold 6037EX - Manual (Page 177)

Programming Techniques 6-3
Quantity
Use either or both of the following methods to control the
quantity of labels printed:
♦ Set up a print loop by placing any C/C++ loop construct
around the code that prints the labels. The number of times
the loop executes is the number of labels printed.
♦ Adjust the batch packet’s quantity parameter before
submitting the batch. Refer to the Packet Reference Manual
for more information.
Peel Mode/Non-Peel Mode
In peel mode, the printer separates labels from the backing
paper, which allows you to apply labels immediately. In non-
peel mode, the printer feeds the supply through the printer in a
continuous strip. In a print loop, the printer may or may not be
in peel mode. The mode you want depends on how you load
the supplies in the printer. Refer to the
Equipment Manual for
more information.
You cannot use linerless supplies in peel
mode.
Feed Mode
Feed mode determines how the printer prints the labels. There
are two feed modes:
Mode Description
Continuous The printer prints all labels together (in one strip)
immediately, with no operator intervention.
On-Demand The printer prints the labels one at a time. It does
not print the next label until the operator removes
the previous one.
You specify the feed mode in the batch packet with the batch
control line’s second parameter. Refer to the
Packet Reference
Manual for more information.