Philips DVD Recorder/Hard Disk DVDR 725H/02 - Manual (Page 8)

3
Important
ACaution! Visible and invisible laser radiation. If the cover is
open, do notlook atthe beam.
Because of the risk of eye injuries, only qualified service
engineers should open the device and carry out
maintenance or repair work.
ALASER
Typ: Semiconductor lasers InGaAlP (DVD), AlGaAs(CD)
Wavelength: 660nm (DVD), 780nm (CD)
Output power (outside the lens): 20mW (DVD+RW write),
0.8mW (DVD read), 0.3mW (CD read).
Beam divergence: 82 degrees (DVD), 54 degrees (CD)
ADanger. High voltage! Do not open.
Do not insert objects into the ventilation slots and fan
openings!
You run the risk of getting an electric shock.
AThe device does not contain any user-serviceable parts. Please
leave all maintenance work to qualified personnel.
AThere are some components in the DVD recorder that keep
running as long as the recorder is connected to the power supply.
To switch off the DVD recorder completely, you must unplug it
from the power supply.
AIf you disconnect the DVD recorder from the mains, make sure to
take the plug out of the wall socket and not just remove the
connector from the
4MAINS J socket at the back of the unit.
Children playing near the device could suffer injuries at the free
end of the cable.
AMake sure that air can circulate freely through the ventilation slots
on the side and the fan opening at the back of the device to avoid
overheating. The device should be placed on a firm surface.
ADo not insert any objects into the openings or ventilation slots of
the device.
C These operating instructions have been printed on non-polluting
paper.
C Please dispose of old batteries safely.
C Please take the packaging to your local recycling center.
C This electronic equipment contains several materials that can be
recycled. If you are disposing of an old device, please take it to a
recycling center.
BDo not switch on the device immediately after transport from
a cold to a warm room or vice versa, or under conditions of
extreme humidity.
Wait at least three hours after transporting the device. The DVD
recorder needs this time to acclimate to its new environment
(temperature, relative humidity, etc.).
BWhen installing the recorder in a cupboard, ensure there is a gap
of approximately 5 cm (2 inch) around the recorder to enable air
to circulate freely and prevent overheating.
BMake sure that no objects or liquids enter into the DVD recorder.
Do not place vases or the like on the DVD recorder. If you spill
liquid into the recorder, immediately disconnect it from the power
supply and call after-sales service for advice.
BKeep the DVD recorder away from radiators and other heat
sources and protect it from direct sunlight.
BDo not place any combustible objects on the device (candles, etc.).
Important instructions for the HDD
The built-in HDD of this DVD recorder is sensitive to shocks,
temperature fluctuations, and vibrations.
DO NOT MOVE THE SET WHEN SWITCHED ON !
because the HDD is always running and can be damaged.
Please observe the following precautions:
BAvoid shocks or vibrations
BDo not cover the ventilation openings of the cooling fan
BDo not operate the device under high temperatures, and do not
expose it to temperature fluctuations
BDo not pull the mains plug from the wall outlet before the device
is switched off using STANDBY m 2 .
BBefore bringing the device to a workshop for repair, store all
important data of the HDD on a DVD+RW, DVD+R. See 'The
archive function'.
The workshop will not assume any liability for the loss of the
stored data.
BPhilips will notassume any liability for damage or loss of
stored data.
Warnings/information