Philips DVD Recorder/Hard Disk DVDR 725H/02 - Manual (Page 31)

26
Allocating a decoder
Some TV channels send coded TV signals that can only be viewed
properly with a purchased or rented decoder. You can connect such a
decoder (descrambler) to your DVD recorder. The following function
automatically activates the connected decoder for the TV channel you
want to watch.
Preparation:
•) Switch on the TV, and if necessary, select the programme number
for the DVD recorder.
•) Switch on the DVD recorder.
1 Use the CHANNEL q P and CHANNEL r S buttons or the
number buttons 0..9 on the remote control to select the TV
channel for which you want to use the decoder.
O If necessary, use the TUNER 0 button to switch to the
internal tuner.
2 Press the BROWSER HDD H button and then the SYSTEM
MENU A button on the remote control.
P
The 'SYSTEM MENU' appears.
3 Select 'Setup' using B O .
4 Press C M to select 'System'.
5 Select the line 'Installation' using B O and confirm with
C M .
P
A message appears on the screen that the change of this
setting will flush the 'Time Shift Buffer'.
O If the 'Time Shift Buffer' contains important recordings, save
them with the REC/OTR
n 1 button first. Refer to the
chapter 'The Time Shift Buffer'.
6 Select 'Yes' with D K and confirm with OK L .
O If the message window was closed, confirm the line with
C M again.
7 Select 'Manual search' using B O or A I and confirm with
C M .
Installation
Manual search
Channel/freq. CH
Entry/search 01
Programme number 01
TV channel name BBC1
Decoder Off
TV system PAL-BG
NICAM On
Fine tuning 0
To store
Press OK
8 Select 'Decoder' using B O or A I .
9 Select 'On' with C M .
O To switch off the decoder use C M to select 'Off' (Decoder
switched off).
0 Confirm with OK L .
A To end, press SYSTEM MENU A .
Your decoder has now been allocated to this TV channel.
ENGLISH
Additional installation features