Planet Technology WGSW-2620P - Manual (Page 119)

SNTP Configuration Interface
4.7.14 802.1X Configuration
When enabling the IEEE 802.1X function, you can configure the parameters of this function. To enable
the IEEE 802.1X function, go to Administrator ' Switch Setting ' Misc Config.
4.7.14.1 System Configuration
1. Radius Server IP: set the Radius Server IP address.
2. Server Port: set the UDP destination port for authentication requests to the specified Radius
Server.
3. Accounting Port: set the UDP destination port for accounting requests to the specified Radius
Server.
4. Shared Key: set an encryption key for use during authentication sessions with the specified radius
server. This key must match the encryption key used on the Radius Server.
5. NAS, Identifier: set the identifier for the radius client.
6. Click
Apply
button.