Planet Technology WLS-1280 - Manual (Page 94)

91
automatically use the fastest rate possible.
Parameters
y Disassociated Timeout: The AP will be disassociated after idling for the minutes specified.
y Fragment Threshold: Breaking a packet into smaller units when transmitting over a network medium
that cannot support the original size of the packet.
y CTS/RTS Threshold: Request To Send. A packet sent when a computer has data to transmit. The
computer will wait for a CTS (Clear To Send) message before sending data.
y Beacon Interval (ms): Enter a value between 20 and 1000 msec. The default value is 100 milliseconds.
The entered time means how often the beacon signal transmission between the access point and the
wireless network.
y Preamble Type: The length of the CRC (Cyclic Redundancy Check) block for communication between
the Access Point and roaming wireless adapters. Select either Short Preamble or Long Preamble.
y Tx Power Level: Choose which Tx power level desired from the drop-down menu.
802.11b
y Protection Type: Select a protection type from the drop-down menu.
y Short Slot Time: Choose to enable or disable.
y Protection Mode: Select a protection mode from the drop-down menu.
y Protection Rate: Choose a suitable protection rate.
Options:
y Wireless Separation: Choose to enable or disable.
y Worldwide Mode (802.11d): Choose to enable or disable.
y XR(eXtended Range): Choose to enable or disable.
y WMM Support (Wi-Fi Multimedia): Choose to enable or disable.
Profile Configuration: Click “Configure” to set each individual profile.