Printronix T5000R - Manual (Page 72)

70
Appendix B
Explanation:
1. The Compression Algorithm value (Byte 8) is not a valid or supported
value.
2. The (Pel) Data Format value (Byte 9) in the Write Image Control
command is not X'00'.
Alternate Exception Action: None.
Explanation:
1. The Pel Count Scale Factor value on the Write Image Control command
is not a valid or supported value.
2. The Scan Count Scale Factor value on the Write Image Control command
does not equal the Pel Count Scale Factor.
Alternate Exception Action: None.
Explanation: The Font Inline Sequence parameter in a Load Font
Equivalence command is not a valid or supported value.
Alternate Exception Action: None.
Explanation: The Scan Line Direction parameter value on the Write Image
Control command is not a valid or supported value
Alternate Exception Action: None.
Explanation: The Scan Line Sequence Direction value specified on the
Write Image Control command is not plus ninety degrees from the Scan Line
Direction value.
Alternate Exception Action: None.
NOTE: Plus ninety from 270, (X'8700') must be X'0000'.
X '024601' Invalid WIC Source Image Format
X '024701' Invalid WIC Scale Factor Value
X '024702' Invalid LFE Font Inline Sequence
X '024801' Invalid WIC Scan Line Direction
X '024901' Invalid WIC Scan Sequence Direction