Printronix T5000R User Manual

Page 64

Appendix B

Explanation: A data structured field has been received in a WGC or WBCC

command that is less than the minimum allowable length.
Alternate Exception Action: None.

Explanation: The length of the IPDS command header is too small.

Alternate Exception Action: None.

Explanation: The End Page control was encountered before a text
suppression ended.

Alternate Exception Action: Process the object as if the corresponding End

Suppression control sequence appeared at the end of the object. That is, all
of the data following the Begin Suppression control sequence in the object is
processed and suppressed.

Explanation: The printer received a command whose response continuation
bit is on but there is no response to continue.

Alternate Exception Action: None.

Explanation: The reference system specified in the Area Position structured
field of the WGC or WBCC command is not a valid or supported value.

Alternate Exception Action: None

Explanation: A Write Text or Write Graphics command is required to
complete a partial order, control, or double-byte character code and another
command was received other than an XOA command.

Alternate Exception Action: None.

'020205' Invalid Data Structured Field Length

'020302' IPDS Command Header Length Too Small

'020401' End Page Encountered During Active Suppression

'020402' Acknowledge Reply Response Continuation Request is

Invalid

'020405' Area Position Reference System is Not Supported

'020501' Invalid Spanning Sequence