Printronix T5000R User Manual
Page 65
Specification Check-General — X'02'
63
Explanation: Unsupported advancement of the baseline coordinate toward
the I-axis.
Alternate Exception Action: None.
Explanation: The unit-base (measurement units) specified in the Output
Control or the Data Descriptor structured field of the WGC or WBCC
command is not a valid or supported value.
Alternate Exception Action: None.
Explanation: Begin Suppression encountered in the same unit (page,
segment or overlay) before previous suppression in that unit ended.
Alternate Exception Action: None.
Explanation:
1.
The units specified in the Output Control or the Data Descriptor structured
field of the WGC or WBCC command is not a valid or supported value.
2.
The result of the calculation cannot be represented in the printer. This
may result from the WGC GDD window limits being very close together.
3.
Coordinate overflow while scaling graphics. Possible if scaling
coordinates require multiplication by a value greater than 1.
Alternate Exception Action: None
Explanation: The extents specified in the Output Control or Data Descriptor
structured field of the WGC or WBCC command are not a valid or supported
value.
The window values of the WGC GDD structured field are not consistent;
therefore, the value of XL is larger than the value of XR or the value of YB is
larger than the value of YT.
Alternate Exception Action: None.
X
'020502' Unsupported Baseline Move
X
'020505' Structured Field Unit-Base Invalid
X
'020601' Begin Suppression Error
X
'020605' Structured Field Units Invalid
X
'020705' Structured Field Extents Not Supported