Printronix T5000R User Manual
Page 59
Specification Check-Graphics — X'03'
57
Explanation: The Set Current Defaults instruction sets an invalid or
unsupported default for an attribute.
Alternate Exception Action: None.
Explanation: The specific character angle requested is not supported.
Alternate Exception Action: Use the closest angle supported by the printer.
Explanation: An End Prologue was found outside the prologue section of a
segment.
Alternate Exception Action: None.
Explanation: An End Area order has been executed without a Begin Area
order having previously been executed.
Alternate Exception Action: None
Explanation: Begin Area order received while Begin Area is already in
progress.
Alternate Exception Action: None.
Explanation: A Begin Area order has been executed in a segment, and the
end of the segment is reached without an End Area order being executed.
Area fill implementation results are printer dependent.
Alternate Exception Action: None.
X
'030021' Invalid Default
X
'033400' Character Angle Value Not Supported
X
'033E00' Invalid End Prologue
X
'036000' Area Bracket Error
X
'036800' Begin Area Received Incorrectly
X
'036801' Area Truncation Error