Philips intelligent remote control - Manual (Page 41)

FAQ 39
FAQ
Can I program a button to execute more than one command?
No, you canÕt. However, you can create a macro to execute a sequence of
commands (see p. 30).
How do I program source switching?
See ÒLearning device actionsÓ on page 22.
How can I program, label or delete buttons on home panels?
You can do this via the Device menu. All changes you make to the devices in the
Device menu are automatically updated in the Home menu.
How do I reset the Remote Control?
Normally, you never have to reset the Remote Control. However, if the Remote
ControlÕs display freezes or if you notice unusual behavior, you might need to
reset. You will not lose any saved programmed commands or macros.
· Carefully press the reset button on the back of the Remote Control with a
paperclip or sharp pencil.
The Remote Control restarts and beeps to indicate it is ready for use.
How do I revert to the original configuration?
Reverting to the original configuration restores the Remote ControlÕs devices and
commands to its state when you purchased it. This means that all programming is
lost permanently. Normally, you never have to revert the Remote Control.
1 Touch and hold the Remote Control icon for a few seconds.
The first setup panel appears.
2 Scroll to the second setup panel.
3 Tap the Revert button.
4 Tap Revert to confirm the action.