Philips intelligent remote control - Manual (Page 23)

Getting the Maximum out of it 21
Learning Commands
You can program the Remote Control commands by transmitting infrared signals
from your existing remote controls to the Remote ControlÕs learning eye. To do
this, place the Remote Control and the deviceÕs remote control on a flat surface, 10
to 20 cm (4 to 8 inches) apart.
The following buttons can be programmed:
· control panel buttons,
· device actions,
· direct-access buttons and Left/Right buttons.
You cannot program Home menu buttons directly. You have to program them via
the Device menu (see p. 22).
The Remote Control also offers empty control panel buttons which you can
program and label as existing buttons. They are only visible in Learn and Label
mode and appear without label or with label (intended for a specific function). You
will also see previously deleted buttons: you can restore them by reprogramming
them or you can reuse them for other commands.