Philips intelligent remote control - Manual (Page 25)

Getting the Maximum out of it 23
6 Press and hold the button the Remote Control has to learn as device action on
your deviceÕs original remote control. The command for the device action is
assigned to the Device button in the Home menu and in the Device menu.
If the Remote Control has learned the command successfully, OK flashes on
the display. You can let go of the button youÕre holding.
If the Remote Control has not learned the command successfully, you hear a
short buzz and FAIL appears on the Remote Control icon.
7 Program all other device actions you want and return to Use mode via the
Mode button.
Learning Direct-access and Left/Right Buttons
Direct-access and Left/Right buttons can be programmed with a global function
or with functions per device.
· Buttons with global functions always execute the same command, no matter
what device is active.
· Buttons with functions per device execute commands depending on the active
device. For example, the Left button is the Play command when the VCR is
active.
Note
Per device functions overrule global functions. For example, when you
program the Volume buttons globally, but you assign a specific function to
them with the tuner, the specific command will be executed when the tuner is
the active device.
Learning a button per device
1 Switch to the device for which you want to program the button.
2 Complete instructions 2 to 7 in ÒLearning control panel buttonsÓ on page 22.
Instead of tapping a button on the touch screen, press the direct-access button
or Left/Right button you want to program.
The label of the button you have pressed (e.g. chan+ or left) starts flashing on
the Remote Control icon.
Learning a button globally
1 Tap the Home menu button .
2 Complete instructions 2 to 7 in ÒLearning control panel buttonsÓ on page 22.
Instead of tapping a button on the touch screen, press the direct-access button
or Left/Right button you want to program.
The label of the button you have pressed (e.g. chan+ or left) starts flashing on
the Remote Control icon.