Philips intelligent remote control - Manual (Page 24)

Getting the Maximum out of it 22
Learning control panel buttons
1 Navigate to the control panel buttons you want to program.
2 Switch to Learn mode via the Mode button .
Additional empty buttons appear: they can be programmed and labeled as
existing buttons.
3 Point the deviceÕs original remote control to the Remote ControlÕs learning
eye as shown on page 20.
4 Tap the Remote Control button you want to program.
The button starts flashing.
5 Press and hold the corresponding button on your deviceÕs original remote
control.
If the Remote Control has learned the command successfully, OK flashes on
the Remote Control icon. You can let go of the button youÕre holding.
If the Remote Control has not learned the command successfully, you hear a
short buzz and FAIL appears on the Remote Control icon.
6 Program all other buttons you want and relabel them if necessary (see p. 23).
7 Return to Use mode via the Mode button.
Learning device actions
A device action is a command that is assigned to a Device button on the Home
menu or a device in the Device menu. The action is executed every time you
select the device.
Note
When you program a device action, RC codes are sent the moment you select
the device. This might affect the operation of the active device. For switching
to another device without sending RC codes and without affecting the active
device, see page 15.
1 Make sure the device tab is active.
The device tab is active when the name of a device is displayed.
2 Switch to Learn mode via the Mode button .
3 Point the deviceÕs original remote control to the Remote ControlÕs learning
eye as described above.
4 Tap the device tab to open the Device menu.
5 Touch and hold either the Remote ControlÕs Left or Right button (both
labeled Device) and tap the device you want to program.
Even when you want to program a device action for the currently active
device, you have to tap it in the Device menu.
The label device starts flashing on the Remote Control icon.