Paradyne 8784 - Manual (Page 9)

8784-A2-GB20-30 February 2001 v
About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate the
2-port Hotwire 8784 Time Division Multiplexer Symmetric Digital Subscriber Line
(TDM SDSL) Termination Unit, and is intended for installers and operators.
Document Summary
Section Description
Chapter 1, About the Hotwire
8784 Termination Unit
Describes the Hotwire 8784 Termination Unit’s
features and capabilities.
Chapter 2, Using the
Asynchronous Terminal Interface
Provides instructions for accessing the user interface
and navigating the screens.
Chapter 3, Initial Startup and
Configuration
Provides procedures for configuring the unit.
Chapter 4, Monitoring the Unit Describes using the LEDs, status, and network
statistics to monitor the unit.
Chapter 5, Testing Provides information about available tests and test
setup.
Chapter 6, Messages and
Troubleshooting
Provides information on SNMP traps, device
messages, and troubleshooting.
Chapter 7, Security Presents procedures for creating a login, setting the
effective access levels, and controlling SNMP
access.
Chapter 8, IP Addressing Provides information and examples regarding IP
addresses.
Appendix A, Configuration
Options
Contains all configuration options, default settings,
and possible settings.
Appendix B, Standards
Compliance for SNMP Traps
Contains SNMP trap compliance information.
Appendix C, Connector Pin
Assignments
Lists the pin assignments for the front panel DTE
connector.