Planet Technology DVR-860 - Manual (Page 69)

-63-
APPENDIX 1 INSTALL HDD
◎ HDD Installation
DVR-460
Step 1: Loosen the screws on the upper cover and open the upper cover of the DVR
Step 2: Screw out the HDD bracket. For the positions of the HDD bracket screws, please refer to the figure below.
Step 3: Get suitable brand HDD and set the HDD mode (master or single).
Step 4: Screw HDD onto the HDD bracket, two screws for each side. And then screw the HDD bracket back to the DVR
base. (Refer to Fig.1 & 2).
Step 5: Connect the HDD to the power connector and IDE BUS (make sure to align the HDD precisely for pin connection)
(Refer to Fig. 3)
Step 6: Close the upper cover of the DVR and fasten all the screws you loosened in the step 1. (Refer to Fig. 4 & 5)
DVR-860
Step 1: Loosen the screws and open the upper cover.
Step 2: When install the first HDD, please set the jumper on the HDD to “Master” mode.