Planet Technology DVR-860 - Manual (Page 15)

FRONT AND REAR PANELS
-9-
2.2 Rear Panels
2.2.1. DVR-460
USB
INP UT
DC 19V V D /
1
LOOP
EXTERNAL I/O IR
INP UT
2
LOOP LOOP LOOP
3
INP UT
4
INP UT
LAN
ACT .
LINK
1
CALL MONITOR
IN OUT
1) 75Ω / HI-IMPEDANCE
When using LOOP function, please switch to HI-IMPEDANCE. Otherwise, please switch to 75Ω.
2) LOOP / INPUT (For channel 1~4)
LOOP: Video output connector.
INPUT: Connect to video sources, such as cameras.
Note: If you want to playback the video with audio, please connect an audio camera to the correct channel.
Please connect audio camera to INPUT 1 on the DVR rear panel
3) MONITOR
Connect to MAIN monitor.
4) CALL
Connect to CALL monitor to show the channel display one by one.
When any alarm is triggered, CALL monitor will show the image of the triggered channel for a period of time.
5) Audio IN
Connect to audio sources, such as cameras equipped with the audio function.
When users start recording, the audio input will also be recorded.
6) Audio OUT
Connect to a monitor or speaker with 1 mono audio output.
7) USB
Support USB flash drive firmware update and file backup.
Note: For the list of compatible USB flash drives, please refer to “APPENDIX 5 COMPATIBLE USB FLASH
DRIVE BRAND”.
8) D/V Port
Connect to VGA monitor.
9) IR
Connect the IR receiver for remote control.
10) EXTERNAL I/O
Insert the supplied 15PIN DSUB to this port for connecting external devices (external alarm, PTZ camera, etc).