Planet Technology DVR-860 - Manual (Page 44)

MENU FUNCTION
-38-
6.6.4 Audio Backup and Playback
If you want to backup images with audio, please connect the cameras to the correct channels. The audio channels
of DVR-460 are CH1, and channels of DVR-860 are CH1, CH2, CH3, CH4.
Note: For detailed camera connection, please refer to section “3.3 Camera Connection”.
For detailed backup instruction, please refer to section “6.4.8 Backup”.
For detailed playback instructions, please refer to section “4.2 Playback”. For detailed playback instructions on the
remote PC side, please refer to section “7.4 Playback Operation”.
6.6.5 PTZ Camera Setup and Control
‧ PTZ connection: Please refer to section “3.3.2 PTZ”.
‧ PTZ ID, protocol, baud rate setting at the DVR side: Please refer to section “6.4.5 Remote”.
‧ PTZ ID, protocol, baud rate setting at the remote AP software side:
Please refer to section “(1) Device” at page 52 (AP software system configuration).
‧ PTZ control at DVR side:
Press these
SEQ.
P.T.Z
or two buttons on the DVR-460 front panel at the same time to enter / exit the PTZ
control mode. Press “ ” + “ ” buttons of DVR-860 at the same time to enter / exit the PTZ control mode.
In the PTZ control mode, press "＋" button to zoom in, press "－" button to zoom out, and press "UP”, “DOWN”,
“LEFT” or “RIGHT" buttons on the DVR front panel to adjust the PTZ angle.
‧ PTZ control at AP software side: Please refer to section “7.3.2 PTZ Camera Control Panel”.