Planet Technology DVR-460 - Manual (Page 30)

DVR-460 User Guide 30
Note:
The default setting of SS is 03, which means once an object is detected more than 3 grids, the
will get triggered. So the value of SS must be less than the number of grids that you set system
up for the motion detection area.
“TS” is to set the sensitivity regarding how long one object stays in the detection area
nd triggers the recording. The smaller the value is, the higher sensitivity for motion
lt
2.
6)
a
detection.
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The defau
setting is 0
RE (Reference)
“RE” is to set a reference for detection. The default value is 10, which means the DVR
ontinuous images at one time according to the sensitivity of LS, SS,
7)
will compare 10 c
TS simultaneously.
The bigger the value is, the higher sensitivity for motion detection. The highest
sensitivity is 61.
ALARM
Select N.C. (Normally Closed) / N.O. (Normally open) / OFF for the alarm polarity. The
arm value is OFF.
7.3 Remote
default al
, you can set up remote devices to work properly.
ove the cursor to “REMOTE”, and press ”ENTER”. You will see a similar screen as the
REMOTE
In this menu list
M
following:
ADVANCE
CAMERA
TITLE
DEVICE ID PROTOCOL RATE
DET CH1 PTZ P-D 2400 ECTION 000
REMOTE CH2 CAMERA 000 NORMAL 2400
DISPLAY CH3 CAMERA MAL 000 NOR 2400
ALERT CH4 CAMERA 000 NORMAL 2400
SYSTEM
NETWORK SE CONSULT TALLER FOR NCE SE PLEA YOUR INS ADVA TTING
BACKUP uv SELECT s BACK t NEXT EN ER T
HDD INFO
EVENT LOG