Planet Technology DVR-460 - Manual (Page 29)

4-CH MPEG-4 Digital Video Recorder 29
1) TITLE
Show the camera title of each channel set in “CAMERA”.
2) DET
Select if you want to activate the motion detection function for the selected channel
FF).
3)
(ON/O
AREA
Press “ENTER” button to set the detection area. You will see similar screens as the
g:
s
a under detection.
followin
Pink blocks represent the area that is not being detected while the transparent block
are the are
Note:
If the connected video output device is LCD monitor, but the “MONITOR OUT” setting in
AY” menu is "MAIN", the motion detection area setting will be disabled. “DISPL
Transparent blocks are the area
under detection.
Press “ENTER” button to confirm
the start area.
Press “LEFT” / “RIGHT” button to
choose the width of the detection a ea. r
Press “UP” / “DOWN” button to
choose the height of the area.
You can also set up
multi-detection area.
When any movement is detected, you
will see the grids are flashing.
4) LS (Level of Sensitivity)
“LS” is to set the sensitivity of comparing two different images. The smaller the value is,
otion detection. The highest sensitivity setting is 00, and the
5)
the higher sensitivity for m
lowest sensitivity setting is 15. The default value is 07.
SS (Spatial Sensitivity)
“SS” is to set the sensitivity for detecting the size of one object (the number of the grids)
ller the value is, the higher sensitivity for motion detection. on the screen. The sma
The highest sensitivity setting is 00, and the lowest sensitivity setting is 15. The default
setting is 03.