Panasonic KX-PS8100 - Manual (Page 65)

65
Setup
1 Make sure the scanner and printer are turned off.
2 Connect the SCSI cable provided to the scanner’s SCSI
connector A or B and to the printer’s SCSI connector.
3 Make sure the terminator switches (scanner:#4/
printer:#1) are set to ON.
• To change a terminator setting, see page 66 .
4 Connect the power cord to the scanner’s AC inlet and to
an AC outlet.
5 Connect the other power cord to the printer’s AC inlet
and to an AC outlet.
NOTE:
• The Printer function is also available if the printer is connected to the
computer with a parallel interface cable.
DCIS stand alone
system
Scanner’s SCSI
connector
Printer’s SCSI
connector
SCSI cable
1 2 3 4
ON
12
3
4
ON OFF
Scanner
Printer