Options, Upgrade options, See chapter 10 “options – Panasonic KX-PS8100 User Manual
Page 272
Chapter 10
272
Options
For the List of options, refer to the
Setup Manual
.
Upgrade options
The following upgrade options and consumables are available for the
KX-PS8100 from your local Panasonic reseller:
•
Hard Disk Drive (KX-PDHD1) for storing print jobs, and additional fonts
(
)
•
32 MB (KX-PEMD2) or 64 MB (KX-PEMD3) SDRAM DIMMs (
Three DIMM slots are available on the printer controller board. Each slot
can support a 16 MB, 32 MB or 64 MB SDRAM DIMM.
NOTE:
•
A minimum of 48 MB of SDRAM is required for duplicating.
•
Ethernet (KX-PNBC5) or Token Ring (KX-PNBC6) card (
You must remove the printer controller board from the back of the
KX-PS8100 printer in order to install or replace the hard disk, add or replace
memory, or install a Token Ring or Ethernet card.
IMPORTANT:
•
To prevent static electricity damage to any of the following components,
touch a grounded metal surface, such as the printer’s bare metal frame
prior to touching the component.
— The interface connectors; SCSI, parallel, and optional network
— ADF interface connector
— Electrical components, connectors inside the printer, any components
on the optional board (hard disk drive, SDRAM DIMMs, Ethernet
network card, or Token Ring network card)
— The connector pins on the optional 2nd cassette feeder for the printer