beautypg.com

Communicator reporting options, Communicator reporting option table – Linear DVS-1200 User Manual

Page 37

background image

35

COMMUNICATOR REPORTING OPTIONS

REPORTING FORMAT

✦ The factory setting causes the communicator to

report using the 4 BY 2 FORMAT. This format allows
four-digit account numbers from 0000 to 9999 and
provides two-digit alarm codes.

STEP #105 ADEMCO CONTACT ID can be chosen as a reporting

format using this step. This format allows 4-digit
account numbers from 0000 to 9999 and provides
verbose report descriptions with Ademco Contact ID
compatible Central Stations.

CALL ROUTING

✦ The communicator can be programmed with three

telephone numbers; primary, secondary, and
supervisory.

✦ The factory setting for the communicator is to

route all calls to the primary telephone number. If
communication is unsuccessful after fi ve attempts
to the primary number, the secondary number
will be dialed for an additional fi ve attempts. If
the secondary number cannot be reached, the
communicator will “sleep” for fi ve minutes before
starting the call process over again. A total of four
sleep cycles (50 call attempts) can occur before the
communicator stops calling.

STEP #86 The communicator can be programmed to report

supervisory events (low battery, trouble, AC failure,
etc.) to the supervisory telephone number instead
of the primary or secondary telephone numbers
using this step.

Communicator Reporting Option Table

CAUTION: If the page alert user code feature

is going to be used, the supervisory number is
reserved for the pager number. DO NOT SET THE
CALL ROUTING OPTION TO “1”.

NOTE: To disable supervisory reports, set call

routing option to “1” and remove the supervisory
telephone number.

NOTE: Do not program the primary and secondary

telephone numbers the same. See the FCC
Telephone Rules and Regulations on the rear
cover of this manual.

COMMUNICATOR REPORTING OPTIONS

STEP

#

PROGRAMMING

FUNCTION

POSSIBLE

VALUES

FACTORY

VALUE

INSTALLATION

VALUE

86

CALL ROUTING

0 = ALL CALLS TO PRIMARY OR SECONDARY NUMBER
1 = ALL ALARM CALLS TO PRIMARY OR SECONDARY NUMBER AND ALL
OTHERS TO SUPERVISORY NUMBER

0

88

ACCOUNT NUMBER

4 DIGITS

EMPTY

89

PRIMARY PHONE NUMBER

UP TO 20 DIGITS

EMPTY

90

SECONDARY PHONE NUMBER

UP TO 20 DIGITS

EMPTY

91

SUPERVISORY/PAGER PHONE NUMBER

UP TO 20 DIGITS

EMPTY

PRESSING THE (A) KEY INSERTS A 1-SECOND DELAY
THE [FIRE] KEY INSERTS A 5-SECOND DELAY
FOR ALL PHONE NUMBERS

⇒ ⇒ ⇒ THE [CHIME] KEY INSERTS A “

*

THE (A) KEY INSERTS A “#” IF IT IS THE LAST DIGIT OF THE PHONE NUMBER

105

REPORTING FORMAT

0 = 4 BY 2; 1 = ADEMCO

0

108

REPORT SYSTEM TROUBLE

0 = NO; 1 = YES

0

110

REPORT FORCE ARMING

0 = NO; 1 = YES

0

111

OPEN/CLOSE

0 = NO; 1 = YES; 2 = MASTER PAC ONLY

0

113

POINT ID REPORTING FOR 4 BY 2 FORMAT

0 = NO; 1 = YES

1

0

5

JKL

HOME

AWAY

0 FOR 4 BY 2
1 FOR ADEMCO CONTACT ID

PROGRAMMING STEP #105

PROGRAM

STORE PROGRAM

1

8

TUV

6

MNO

HOME

AWAY

PROGRAMMING STEP #86

PROGRAM

STORE PROGRAM

0 FOR ALL TO PRIMARY/SECONDARY
1 FOR ALARMS ONLY TO
PRIMARY/SECONDARY