Linear DVS-1200 - Manual (Page 18)

16
✦ The Console can be customized for the specifi c
installation.
✦ A label sheet with sensor location names is
provided with the Console.
✦ Labeling the sensors allows quick and easy
identifi cation of where a door or window is open,
where any alarms have occurred, where a sensor
with a low battery is, or where a sensor with trouble
is.
LABELING THE SENSORS
1. Use a paper clip to remove the clear display
window.
2. Bend down the tabs on the sensor number card
and fi t it onto the Console.
3. Open one protected door/window to light its sensor
status light on the Console.
4. Choose a label that describes the sensor location,
or write the location on a blank label, and stick it in
the area to the right of the sensor light.
5. Close the protected opening that you just labeled.
6. Repeat for each protected opening.
7. Stick the WIRELESS KEYPAD label in the sensor
number location for the wireless keypad (if used).
8. Replace the clear display window when fi nished.
BEND TABS DOWN
AND INSERT IN
SLOTS
USE SENSOR
LABELS PROVIDED
WRITE IN SPECIAL
LOCATIONS ON
BLANK LABELS
OPEN DOOR
OR WINDOW
TO LIGHT
SENSOR STATUS
INDICATOR
ON CONSOLE
APPLY SENSOR IDENTIFICATION
LABELS TO THE APPROPRIATE
SENSOR LOCATIONS
8. CUSTOMIZING THE CONSOLE