Linear DVS-1200 User Manual

Page 32

AUTOMATION OUTPUT WHILE ARMED

✦ The factory setting causes the Console's

Automation Output to activate when pressing the

key, or when it's triggered with a two-button

remote control.

STEP #73 The Console can be programmed to activate the

Automation Output when the system is armed as
well as when normally triggered using this step.

AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS

✦ The factory setting causes the Console's

Automation Output to activate when pressing the

key, or when it's triggered with a two-button

remote control.

STEP #74 The Console can be programmed to activate the

Automation Output during the exit and Entry Delays
as well as when normally triggered using this step.

AUTOMATION OUTPUT POLARITY

✦ The factory setting causes the Console's

Automation Output to provide a current limited
voltage source when activated.

STEP #75 The Console can be programmed so the

Automation Output provides a current limited
voltage source when deactivated using this step.

REMOTE ACCESS PASSWORD

✦ This password is used to gain access to the Console

when using the RA-2400 remote access software.
The password must be 6-digits long.

STEP #87 Use this step to enter a new remote access

password then log the password in the box below.

DURESS CODE

✦ The duress code will disarm the system, without

any special indications or sounds, but will send the
programmed duress code to the Central Station.
The code should be two or more digits different
than any user code

STEP #92 Use this step to enter the duress code then log the

code in the box below.

MASTER USER CODE

✦ The master user code is 1234 when power is fi rst

applied to the Console.

✦ The master user code can be changed to any 1-5

digit code. Only the master user can access Setup
Mode, restricted users cannot.

✎ NOTE: For maximum security, a 3-5 digit code is

recommended.

STEP #99 Use this step to enter the new master user code

then log the code in the box below.

REMOTE ACCESS PASSWORD:

DURESS CODE:

MASTER USER CODE:

PRS

DEF

HOME

AWAY

PROGRAMMING STEP #73

PROGRAM

STORE PROGRAM

0 FOR STANDARD TRIGGER
1 FOR OUTPUT WHEN ARMED

PRS

GHI

HOME

AWAY

PROGRAMMING STEP #74

PROGRAM

STORE PROGRAM

0 FOR STANDARD TRIGGER
1 FOR OUTPUT DURING
EXIT/ENTRY DELAYS

PRS

JKL

HOME

AWAY

PROGRAMMING STEP #75

PROGRAM

STORE PROGRAM

0 FOR VOLTAGE WHEN OFF
1 FOR VOLTAGE WHEN ON

TUV

PRS

HOME

AWAY

PROGRAMMING STEP #87

PROGRAM

STORE PROGRAM

6-DIGIT REMOTE
ACCESS PASSWORD

WXY

ABC

HOME

AWAY

PROGRAMMING STEP #92

PROGRAM

STORE PROGRAM

1-5 DIGIT DURESS CODE
(3-5 DIGITS RECOMMENDED)

WXY

HOME

AWAY

PROGRAMMING STEP #99

PROGRAM

STORE PROGRAM

1-5 DIGIT MASTER CODE
(3-5 DIGITS RECOMMENDED)