Linear DVS-1200 User Manual
Page 33
31
ADDING ADDITIONAL USER CODES
✦ The Console can be programmed with fi ve restricted
user codes and one page alert user code.
✦ The restricted user codes operate the system as
usual, but cannot access Setup Mode.
✦ The restricted user codes can access a special
Code Mode that can be used to change or remove
any of the fi ve restricted user codes, the page alert
user code, or the duress code.
✦ The page alert user code dials the supervisory
number (programmed for a pager) when it is used
to arm or disarm the system.
✦ A restricted user code is appropriate to give any
user that should be restricted from programming
the Console.
✎ NOTE: For maximum security, a 3-5 digit code is
recommended.
✎ WARNING: NEVER PROGRAM ANY RESTRICTED
USER CODE THE SAME AS THE MASTER USER CODE!
STEPS #93-98
Create any additional user codes using these
steps then log the codes in the boxes to the right.
REMOVING ADDITIONAL USER CODES
STEPS #93-98 Any additional user code can be removed
from the Console by entering the appropriate step
number and pressing TEST.
✦ Because access to programming would be impossible
without a master user code, it cannot be removed
using these steps.
The master user code can be
changed using programming STEP #99.
✎ NOTE: The master user code can be set to the
factory default using the Console master reset
programming step, although all other system
programming will be reset to factory values and all
sensors programmed will be erased.
CONSOLE MASTER RESET
✦ Master resetting the Console will set all of the
programming options back to the factory values. The
master user code will be reset to 1234.
✎ CAUTION: Master resetting the Console will erase the
user codes and remove all programmed sensors. All
Console and communicator programming values will
be reset to the factory defaults.
1.
Start with the system in Test Mode (Setup Mode
cannot be reached from any other mode).
2.
From Test Mode, enter the master user code then
press TEST.
✴ A “Gong” and fi ve “Beeps” will sound, signaling that the
system is in Setup Mode.
3.
Enter programming STEP #999 then press TEST.
4.
Enter 999 again then press TEST again.
✴ A “Bing” will sound to indicate the beginning of the reset
process. This process will take up to 10 seconds while the
memory is being reset.
✦ The system will revert to the fi rst time power-up
condition and the new master user code will be 1234.
Go to the “Basic Console Programming” section of
this manual to begin re-programming the system.
STEP
CODE FUNCTION
CODE ENTERED
STEP #93
RESTRICTED USER CODE #1
STEP #94
RESTRICTED USER CODE #2
STEP #95
RESTRICTED USER CODE #3
STEP #96
RESTRICTED USER CODE #4
STEP #97
RESTRICTED USER CODE #5
STEP #98
PAGE ALERT USER CODE
PROGRAMMING STEPS
#93 TO 98
PROGRAM
STORE PROGRAM
1-5 DIGIT CODE
(3-5 DIGITS RECOMMENDED)
9
WXY
TEST
KEYPAD CODE
PROGRAMMING STEPS
#92 TO 98
REMOVE
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
STEP #999
FOR
MASTER
RESET
DONE
PRESS TEST,
1 BING SOUNDS,
WAIT ABOUT 10
SECONDS
TEST
9
WXY
9
WXY
TEST
9
WXY
PRESS
TEST
9
WXY
9
WXY
TEST
9
WXY
ENTER 999
TO OK THE
MASTER
RESET
USE THESE EXACT
KEYSTROKES
TO PERFORM A
MASTER RESET