Linear DVS-1200 User Manual
Page 31
29
AUTOMATION OUTPUT MODE DURING ALARM
✦ The factory setting causes the Automation Output
to fl ash if it is programmed to activate during or
after an alarm.
✎ NOTE: For the Automation Output to activate
during or after an alarm, that function must be
enabled with Programming Step 71 or 72.
STEP #68 The output can be programmed to be a steady
output using this step.
AUTOMATION ACTIVATION TONE
✦ The factory setting causes the Console to sound a
“Bing” when the Automation Output is activated by
pressing the
key, or when it's triggered with a
two-button remote control.
STEP #69 This sound can be silenced using this step.
REMOTE CONTROL ARM/DISARM CHIRP
✦ When arming with the portable remote control, the
factory setting causes the Console to “chirp” once
when armed, twice when disarmed, and three times
when arming with sensors bypassed.
STEP #70 These chirps can be silenced using this step.
✎ NOTE: If these chirps are silenced, it is
recommended to program the Automation Output
to be active when the system is armed, so a light
can be triggered displaying the arming status of
the Console.
AUTOMATION OUTPUT ON DURING AND AFTER ALARM
✦ The factory setting causes the Console's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #71 The Console can be programmed to activate the
Automation Output during and after any alarms as
well as when normally triggered using this step.
✎ NOTE: The output will continue until the fl ashing
sensor status lights are cleared.
AUTOMATION OUTPUT ON DURING ALARM
✦ The factory setting causes the Console's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #72 The Console can be programmed to activate the
Automation Output during alarms as well as when
normally triggered using this step.
✎ NOTE: The Automation Output can be programmed
to fl ash or be steady during alarm, see
Programming Step 68.
6
MNO
8
TUV
HOME
AWAY
PROGRAMMING STEP #68
PROGRAM
STORE PROGRAM
0 FOR FLASHING OUTPUT ON ALARM
1 FOR STEADY OUTPUT ON ALARM
6
MNO
9
WXY
HOME
AWAY
PROGRAMMING STEP #69
PROGRAM
STORE PROGRAM
0 FOR BING TONE OFF
1 FOR BING TONE ON
7
PRS
0
HOME
AWAY
PROGRAMMING STEP #70
PROGRAM
STORE PROGRAM
0 FOR CHIRPS OFF
1 FOR CHIRPS ON
7
PRS
1
HOME
AWAY
PROGRAMMING STEP #71
PROGRAM
STORE PROGRAM
0 FOR STANDARD TRIGGER
1 FOR FLASHING DURING
& AFTER ALARM
7
PRS
2
ABC
HOME
AWAY
PROGRAMMING STEP #72
PROGRAM
STORE PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT DURING ALARM