Linear DVS-1200 - Manual (Page 24)

22
✦ Adding additional sensors will increase the
protection provided by the system.
✦ All ground-level perimeter openings and accessible
upper-story openings need protection.
✦ Motion detectors can protect interior areas and
areas where valuables are kept.
ADDING SENSORS TO THE SYSTEM
1. Always start with the Console in Test Mode (enter a
user code and press TEST).
2. Enter the master user code then press TEST.
✴ A “Gong” and fi ve “Beeps” will sound.
✴ The sensor status indicators will light for each sensor
programmed into the Console.
3. Enter an unused sensor number from 01-12 (you
must enter two digits, example: 5 = 05).
✎ NOTE: A sensor can be programmed into more
than one location. Be sure to choose an UNUSED
sensor number. If a sensor gets entered into more
than one location, delete the duplicates using the
remove sensor function.
✴ The sensor status indicator light will fl ash for the sensor
number selected.
4. Activate the sensor. (To add a wireless keypad,
press the keypad's key.)
✴ A “Bing” tone will sound when the sensor is programmed
into the Console and the sensor status indicator will stay lit.
✴ A “Buzz” tone will sound if there is already another sensor
programmed to that sensor number.
5. Enter another sensor number, or exit Setup Mode by
pressing the key then press OFF for three seconds.
REMOVING SENSORS FROM THE SYSTEM
✦ If a previously programmed sensor isn't going to be
used with the system anymore, or it's a duplicate that
has been entered into more than one sensor location,
it should be removed from the Console's memory.
1. Start with the Console in Test Mode.
2. Enter the master user code then press TEST.
✴ A “Gong” and fi ve “Beeps” will sound.
✴ The sensor status indicators will light for each sensor
programmed into the Console.
3. Enter the sensor number (from 01-12) that you
want to remove (you must enter two digits, example:
5 = 05).
✴ The sensor status indicator light will fl ash for the sensor
number selected.
4. Press TEST.
✴ A “Bing” tone will sound when the sensor has been removed
and the sensor status indicator will turn off.
5. Enter another sensor number, or exit Setup Mode by
pressing the key then press OFF for three seconds.
11. CUSTOMIZING THE SYSTEM
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
SENSOR
NUMBER
TO REMOVE
DONE
TEST
TEST
1 BING
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
NEW
SENSOR
NUMBER
ACTIVATE
SENSOR
DONE
TEST