Sharp DV-NC70(RU) - Manual (Page 86)

GB 84
DVD DVD
About the Function Control Screen
Angle setting
You can change the angle of view when playing a DVD disc that
contains scenes recorded from multiple angles.
Use the following procedure to perform the Angle setting.
1
Press FUNCTION CONTROL during playback.
• The Function control screen appears.
2/5
8/3‰
‰1:3‰:‰8
2 ENGLISH
1
1 51ch
ON
ON
.
T T T
C C C
G ENTER RETURN
SELECT
ENTER
BIT RATE Mbps
0 5 10 D
DVD
2
Use ' or " to select and then press ENTER.
2/5
8/3‰
‰1:3‰:‰8
2 ENGLISH
1
1 5.1ch
ON
ON
T T T
C C C
G ENTER RETURN
SELECT
ENTER
BIT RATE Mbps
0 5 10
DVD
3
Press ' or " to select the angle number you want.
• The number of recorded angles differs depending on the disc used.
2/5
8/3‰
‰1:3‰:‰8
2 ENGLISH
2
1 5.1ch
ON
ON
T T T
C C C
G ENTER RETURN
SELECT
ENTER
BIT RATE Mbps
0 5 10
DVD
4
Press ENTER to confirm the setting.
• You can exit the Function control screen by pressing RETURN or
FUNCTION CONTROL.
• This function can only be used for discs on which scenes shot from
multiple angles have been recorded.
• If no angles are recorded on the disc, xx is displayed.
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE DVD MENU
DISPLAY
EJECT PROG
FUNCTION
CONTROL
PROG/
REPEAT
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
VCR DVD AM/PM INPUT SELECT
PAUSE/STILL REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
ANGLE