Sharp DV-NC70(RU) - Manual (Page 69)

67 GB
8
Select the speed with ' / ".
D A T E P R S T A R T S T O P
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
1 / 2
1 5 / 1 2 4 7 1 2 : 0 0 PM1 2 : 3 0 PM S P
• SP: Standard Play, LP: Long Play, EP: Extended Play
9
Press SET. To programme additional timer settings, repeat steps
3 through 8.
D A T E P R S T A R T S T O P
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
1 / 2
2 / 2
1 5 / 1 2 4 7 1 2 : 0 0 1 2 : 3 0 S P PM PM
: S E L E C T
C L E A R : C A N C E L
S E T : E N T E R M E N U : E X I T
10
Press VCR MENU to return to the normal screen.
11
To set the product for automatic timer recording, press TIMER
ON/OFF and ensure the “
” lights on the VCR Front Panel
display.
• If the timer recording is finished, your product will stop and turn off
automatically. (In this case the cassette is not ejected.)
If a DVD is being played back, the power will not turn off. (The timer
recording is stopped while the power stays on.)
• If the cassette runs out during the timer recording, your product will
eject the cassette without rewinding.
In this case, the timer recording is cancelled (“
” disappears) and
the device turns itself off automatically. However, if a DVD is being
played back, the power will not turn off. (The power stays on.)
• If power is interrupted for more than 60 minutes (power failure, etc.),
all timer settings will be cancelled.
• If TIMER ON/OFF is pressed when there is no cassette loaded, “ ”
flashes for 5 seconds, indicating that timer recording is not possible.
• If TIMER ON/OFF is pressed while a cassette with an uncovered
erasure protection hole is loaded, “ ” flashes and the cassette is ejected.
• When “ ” is lit, regular VCR operation, clock setting and setting/
cancelling/confirming timer positions are not possible. For regular VCR
operation, clock setting and setting/cancelling/confirming timer
positions, press TIMER ON/OFF to disengage the timer (“
”
disappears), and then turn on your Product.
• During timer recording, the timer cannot be set.
• To terminate timer recording, press ËSTOP during timer recording.
• If the same time is input for the start time and the stop time, the timer
setting will be cancelled.
SEPVP D
VCR
L R
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE DVD MENU
DISPLAY
EJECT PROG
FUNCTION
CONTROL
PROG/
REPEAT
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
VCR DVD AM/PM INPUT SELECT
PAUSE/STILL REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
ANGLE
Recording with the Timer