Lexmark 382 - Manual (Page 217)

4 Click Analog Fax Setup.
5 In the Max Speed box, click on one of the following:
2400
4800
9600
14400
33600
6 Click Submit.
Blocking junk faxes
1 Type the printer IP address into the address field of your Web browser.
Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address
in the TCP/IP section.
2 Click Configuration.
3 Click Fax Settings.
4 Click Analog Fax Setup.
5 Click the No Name Fax option.
This option blocks all incoming faxes that have a private caller ID or no fax station name.
6 In the Banned Fax List field, enter the phone numbers or fax station names of specific fax callers you want to
block.
Solving option problems
Option does not operate correctly or quits after it is installed
These are possible solutions. Try one or more of the following:
R
ESET THE PRINTER
Turn the printer off, wait about 10 seconds, and then turn the printer on.
C
HECK TO SEE IF THE OPTION IS CONNECTED TO THE PRINTER
1 Turn the printer off.
2 Unplug the printer.
3 Check the connection between the option and the printer.
M
AKE SURE THE OPTION IS INSTALLED CORRECTLY
Print a menu settings page and check to see if the option is listed in the Installed Options list. If the option is not
listed, then reinstall it. For more information, see the hardware setup documentation that came with the option,
or go to www.lexmark.com/publications to view the option instruction sheet.
Troubleshooting
217