Lexmark 24XX-100 - Manual (Page 75)

Repair Information 4-15
24xx
Power Supply Removal
CAUTION: The power supply may be hot.
1. Turn off the printer and disconnect the power cord at both ends.
2. Remove the top cover. Go to “Covers, Top Removal” on
page 4-8 .
3. Remove the print unit. Go to “Print Unit Removal” on
page 4-28 .
4. Disconnect the power supply cable [A].
5. Remove the five screws [B] securing the power supply to the
bottom cover. Take care not to lose the ground clips which must
be replaced between the ground plate and the board.
6. Remove the two ground wire screws [C].
7. Remove the power supply.