Lucent Technologies MERLIN LEGEND 5 - Manual (Page 274)

MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-56 Adding/Removing a Line
6
Adding/Removing a Line 6
Use this procedure to add a line to or remove a line from the system.
Planning Guidelines 6
If you are adding a new line and need to order a module to connect the line,
coordinate the installation and connection dates to ensure that the new module is
installed before the line is connected to the system.
Task List: Adding/Removing a Line 6
o
Obtain Form 2c, System Numbering: Line/Trunk Jacks. Check the form to
confirm that there is a spare jack.
NOTE:
If you are adding a line but there is no spare jack, you need to add a
new module. Contact your Lucent Technologies representative.
o
Contact your central office (CO) to obtain a new line or to disconnect a line.
o
If you are adding a line/trunk, call Lucent Technologies 1 800 247-7000 to
arrange for a Lucent Technologies technician to connect the line to the
system and set it up (charges may apply). If you are removing a line, it is
not necessary to make any such arrangements.
NOTE:
A new module must be installed before a line is connected to it.
o
After the line is connected and set up or is disconnected, open the System
Programming menu from the console or a PC with SPM to program it as
described in the next task.
o
Assign the line to or unassign the line from a pool, to/from extensions (if it
is a personal line), to/from a calling group, or to/from Remote Access, as
appropriate, following the instructions in the “Telephones” section of
Chapter 3 in
System Programming.
o
Revise the appropriate planning form(s).
o
When you have finished, file the form(s) with the rest of the planning forms.
Programming Instructions 6
See the appropriate procedures in System Programming as noted in the task list
above.