Kodak 4800 User Manual

Page 45

Text mode
Original mode

Installing additional memory A-2

Reference Guide

To remove the DIMM

1 Facing the top of the DIMM, push the side clips gently away from the

DIMM.

DIMM Slot

2 The DIMM should pop up. Pull the DIMM straight up out of the slot.

To install the new DIMM

1 With the large label on the DIMM facing the away from the board,

insert into the slots on the side clips and push straight down. Next
push the left side of the DIMM down while pulling the clip up over the
notch on the DIMM. Repeat on the right side. Make sure the DIMM is
fully seated.

Side clips

2 Carefully reconnect the ribbon cable harness to the connector on the

PC board. Reattach the other connectors removed earlier.

3 Reinstall the right cover and top cover.