Kenwood AX-7 - Manual (Page 66)

66 EN
Preparations
Basic section
Application section
Knowledge section
Timer operation
Setting the timer program
(PROG. TIMER)
In each of PROG. 1 and PROG. 2, the timer data including the operating period and played contents can be
programmed and set to be activated or deactivated.
Adjust the clock before setting the timer £
Connect the related equipment under reference to "System connections" 8~@
1
Make preparations for timer.
Listening to external input sources Listening to DVD/CD Listening to radio
Set a disc.
(Only normal playback is possible.) Radio stations should be preset
beforehand.
‚
Set the timer for a component
connected to external input jacks.
÷ Set the POWER switch of the M-AX7 to the ON position.
÷ The programs of "PROG.1" and "PROG.2" can be activated at the same time.
÷ For the simultaneous programs setting, keep the time intervals of 1 minute or more between timer programs, in order
to avoid time overlapping.
2
Set the timer setting program number.
1
Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select "TIMER
SET". Then press the SET key.
2
Select "PROG.1 SET" or "PROG.2 SET".
3
Press the SET key.
Switching as shown below is done each time the
knob is turned.
"PROG.1 SET"
"PROG.2 SET"
L
R
30 10 5 3 1 0(-dB) 1
1 2 3 4 5
÷ The previously set contents are displayed. (If you do
not want to change them, simply press the SET key.)
÷ When a timer setting has already been made in the se-
lected timer, the setting will be overwritten by the new
setting.
*5613/65-71/EN 06.1.6, 0:54 PM 66