Kenwood AX-7 - Manual (Page 32)

32 EN
Preparations
Basic section
Application section
Knowledge section
CLEAR VOICE setting
1 Press the SOUND SELECTOR key, turn the
INPUT SEL./MULTI CONTROL knob to se-
lect “SURROUND”. Then press the SET key.
2 Turn the INPUT SEL./MULTI CONTROL
knob to select "CLEAR VOICE". Then press
the SET key.
When 2 channels (stereo) has been selected,
switching is done automatically to 4 channels.
When using the remote control, press the
CLEAR VOICE key instead of the operations
1
and 2.
÷ CLEAR VOICE setting is not possible when the
D.EQ RecMode is set to ON.
3 Turn the INPUT SEL./MULTI CONTROL
knob [MULTI CONTROL % / fi key] to select
"Movie", "Music" or "CENTER". Then press
the SET key.
4
Adjust the level of CENTER with the INPUT
SEL./MULTI CONTROL knob [press the
MULTI CONTROL % / fi key on the remote].
or
or
÷ The level can be adjusted at the range of 1 - 10.
÷ Press the SOUND SELECTOR key to end the op-
eration or to cancel it.
Basic use method
For return to 2 channels (stereo)
(LISTEN MODE setting)
1 Press the SOUND SELECTOR key, turn the
INPUT SEL./MULTI CONTROL knob to se-
lect “SURROUND”. Then press the SET key.
2 Turn the INPUT SEL./MULTI CONTROL
knob to select "LISTEN MODE". Then press
the SET key.
When using the remote control, press the LIS-
TEN MODE key instead of the operations
1
and 2.
3 Turn the INPUT SEL./MULTI CONTROL
knob to select "Stereo (EQ)". Then press
the SET key.
Only Stereo (EQ) is displayed when FRONT SYS-
TEM is selected with the speaker settings ( l).
Expansion to a 5.1 channel system is possible by
connection to the 3.1 channel speaker system to
be sold in the future.
When 5.1 CH SYSTEM is selected with the
speaker settings, the LISTEN MODE is switched
as shown below depending on the input source.
l
Stereo (EQ)
Stereo
PL II Movie
PL II Music
PL II Game
Pro Logic
Dolby D
DTS
For details, please refer to the operation instruc-
tions for your equipment.
MAIN UNIT REMOTE
*5613/23-38/EN 06.1.6, 0:53 PM 32