Kodak DCS600 - Manual (Page 266)

A
ppendix A
A-1
Appendix A - Specifications
Type of camera Integral-motor autofocus 35 mm single-lens reflex
Imager size DCS 620 and 620x: 2 million pixels
DCS 660 and 660M: 6 million pixels
Lens mount Nikon F mount
Lens Refer to Appendix C
Focus mode Autofocus and Manual with Electronic Rangefinder
AF area mode Single Area AF and Dynamic AF selectable
Autofocus area Five selectable focus areas
Autofocus mode Single Servo AF with Focus-Priority and Continuous Servo AF with
Release-Priority
Focus Tracking Automatically activated when subject moves
Autofocus detection system Nikon Multi-CAM1300 autofocus module
Autofocus detection range Approximately EV –1 to EV +19 at ISO 200
Autofocus lock Possible once stationary subject is in focus in Single Servo AF; in
Continuous Servo AF, focus can be locked with AE-L/AF-L button
Electronic rangefinder Available in Manual focus mode with AF Nikkor and other AI-type
Nikkor lenses with a maximum aperture of f/5.6 or faster
Exposure metering Three built-in exposure meters ––3D Color Matrix, Center-Weighted,
and Spot
Metering range at ISO 200 with f1.4
lens) EV0 to EV20 in 3D Color Matrix and Center-Weighted, EV2 to EV
20 in Spot
Exposure meter ON/OFF Activated when the Shutter Release button or AF start button is
pressed or when other camera controls are operated; turns off after 8
seconds or when the camera is switched Off
Exposure mode Programmed Auto, Shutter-Priority Auto, Aperture-Priority Auto, and
Manual
Programmed auto exposure control Camera sets both shutter speed and lens aperture automatically;
Flexible Program is possible in increments of 1/3 EV
Shutter-priority auto exposure
control Aperture automatically selected to match manually set shutter speed
Aperture-priority auto exposure
control Shutter speed automatically selected to match manually set aperture
Manual exposure control Both aperture and shutter speed are set manually
Exposure compensation With exposure compensation button; ±5 EV range, in 1/3 EV steps
Auto exposure lock By pressing the AE-L/AF-L button while meter is on