Kodak DCS600 - Manual (Page 182)

11-10
Using the SB-28D
.
1 Turn on the camera.
2 Turn the Speedlight On by
pressing its ON/OFF button for
approximately 0.5 seconds.
The Speedlight’s Ready light
comes on as soon as the flash is
recycled and ready to fire.
☛
If your subject is relatively far
off, wait several seconds after
the Ready light turns on before
capturing the image.
3 Aim the camera at the subject.
4 Press the Shutter Release button
to capture the image.
☛
If the Ready lights on the
Speedlight and inside the
camera viewfinder blink for
approximately 3 seconds after
you capture the image, the
light may be insufficient for
correct exposure. If this
occurs, use a wider aperture or
move closer to the subject
before capturing any more
images.
5 Wait for a few seconds until the
Ready light comes on again
indicating that the flash is ready.
Capture a few more images,
changing exposure
compensation on the flash or on
the camera, as needed.
SEL MODE ZOOM
ISO
ZOOM mm
m 18 13 9 6 4 3 1.5 1 0.6 0.8 2
FLASH ON / OFF
A
STBY