Kenwood TM-V7E - Manual (Page 78)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
72
CONFIGURING PROGRAM FUNCTION KEYS
The Programmable Function keys are [PF], [MR], [VFO],
and [CALL] located on the face of the microphone. If you
prefer, you can change the default functions assigned to
these keys.
To assign a front panel key function:
1 Press one of the following key combinations depending
on which key you want to re-program:
Mic [PF]+[ ] ("PF 1" appears)
Mic [MR]+[ ] ("PF 2" appears)
Mic [VFO]+[ ] ("PF 3" appears)
Mic [CALL]+[ ] ("PF 4" appears)
2 Press the key or key combination on the front panel that
you want to assign.
[PF]
[MR]
[VFO]
[CALL]
Programmable Function Key Default Function
TX Band Select
Memory Recall
VFO Select
Call Channel Select
[F] (1 s), [KEY]
[F] (1 s)
Tuning control
[KEY]
[KEY]+[ ]
[F] + Mic [KEY]
VOL control
[F], [KEY]
[F]
(POWER)
switch
SQL control
[KEY] (1 s)
• The following types of front panel key functions can be
assigned:
• The following types of front panel key functions cannot be
assigned:
• The front panel key will still function normally after
"copying" its function to a Programmable Function key.
• To restore the default functions shown in the table above,
do a Full Reset {page 35}.
Note:
◆ If the LOCK switch located on the rear of the microphone is ON,
you cannot re-program the Programmable Function keys.
◆ Pressing the PTT switch in step 2 assigns the VFO/MR Switch
function.