Kenwood TM-V7E - Manual (Page 69)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
63
DUAL BAND RX
You can select one of three configurations to
simultaneously receive two frequencies. Configuration 1
is the default.
1 Press the right [BAND SEL] to select VHF/VHF RX or
the left [BAND SEL] to select UHF/UHF RX.
2 Press [F], [CONT SEL] to toggle the function ON or
OFF.
• The above display appears when you selected
VHF/VHF RX.
• You can equally use the two bands to transmit (not
simultaneously).
• While transmitting on one band in VHF/VHF or UHF/UHF
mode, the RX function is OFF on the other band.
Note: Receiver performance, for example image rejection and
sensitivity, may be less when using either VHF/VHF or UHF/UHF mode.
If you select the same frequency on both bands, the S-meter reading may
be affected. Also, receive volume may be lower depending on the
position of the VOL control.
BLANKING A BAND DISPLAY
If you have no plans to use one of the bands, you may
want to quit frequency display on the unused band. This
function makes it simpler to read the information you need.
Press [F], [BAND SEL] to toggle the function ON or OFF.
• Press the left [BAND SEL] to blank the VHF band or the right
[BAND SEL] to blank the UHF band.
Note: You cannot operate the blanked band nor use this band to receive
or transmit.
VHF or UHF
VHF
UHF
Configuration TX RX
VHF and UHF
VHF and VHF
UHF and UHF
1
2
3
VOL SQL
CALL CALL
1
2
VOL SQL
CALL CALL
1 2 2