Kenwood TM-V7E - Manual (Page 37)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
31
RECALLING MEMORY CHANNELS
1 Select the desired band.
2 Press [MR] to enter Memory Recall mode.
• The memory channel used last is recalled.
3 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the desired memory channel.
• Clockwise or Mic [UP]:
Increases the channel number.
• Counterclockwise or Mic [DWN]:
Decreases the channel number.
• Empty memory channels cannot be recalled.
• To restore the VFO mode, press [VFO].
Note:
Memory channels can also be recalled via the microphone keypad.
See "Memory Channel Number Entry" {page 75}.
When a split memory channel is recalled, "±" appears on the display.
Press [REV] to display the transmit frequency.
CLEARING MEMORY CHANNELS
1 Select the desired band.
2 Press [MR] to enter Memory Recall mode.
3 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the desired memory channel.
4 Switch OFF the power to the transceiver.
5 Press [MHz]+[ ].
• A confirmation message appears.
6 Press [MR] again.
• The contents of the selected memory channel are erased.
Note: Memory channel 1 cannot be cleared.